| Cross reference lines |
Nov 27, 2020 08:57 PM
by Henrik B.
by Henrik B.
Dear team RadiAnt,
The cross reference lines only work in another plane if you click and activate the plane you want to read, even though you can scoll it already.
It would be nice if any open serie gets activated just by moving the cursor and scolling your desired plane.
Best regards
Henrik B.
The cross reference lines only work in another plane if you click and activate the plane you want to read, even though you can scoll it already.
It would be nice if any open serie gets activated just by moving the cursor and scolling your desired plane.
Best regards
Henrik B.
Dec 1, 2020 12:20 PM
by
by
Dear Henrik, this behavior is intended, as one might want to scroll both views while still having the cross-reference line displayed only in one plane.
However, we'll think about adding an option to automatically switch the lines to another view when it just has been scrolled.
However, we'll think about adding an option to automatically switch the lines to another view when it just has been scrolled.
Dec 3, 2020 06:38 AM
by boskar
by boskar
Personally I see a bit more rework here.
I'd like to see:
1. The thickness of the slice presented along with the center of the slice
2. The reference lines to the entire series, with or without thickness presented
3. Slice numbering in the mode from point two.
I'd like to see:
1. The thickness of the slice presented along with the center of the slice
2. The reference lines to the entire series, with or without thickness presented
3. Slice numbering in the mode from point two.
Dec 11, 2020 02:44 PM
by
by
Sure, those additions will certainly be valuable. As an optional setting, of course.